a. Primary and unpublished: National Archives and Records Service, Santa Rosa Post Office. NARS Record Gr. National Archives and Record Service. Bureau of Appointments, James Knox Taylor. NARS Record Gr. 56, Department of Treasury. b. Secondary and published: Massachusetts Institute of Technology. Technology Review, 14. SANTA ROSA POST OFFICE HABS No. CA-2051 (Page 4) Newman, William A. "The Santa Rosa Post Office Building." The Architect & Engineer of California XXI;49-51. "The Development of Federal Architecture in California Progress from Early Types Shown by Recent Designs." The Architect & Engineer of California LIV;67-73. Santa Rosa Press Democrat.
Issues of March 9, January 15, August 9, January 14, February 18, March 3, March 9, Prepared by Dan Peterson, AIA Fourth Street Santa Rosa, California November PART II. ARCHITECTURAL INFORMATION A. General Statement: 1. Architectural character: The Santa Rosa Post office and Federal Building, designed by James Knox Taylor FAIA, of the Treasury Department, illustrates the beginning of a new design trend for smaller government buildings in communities throughout California. Later examples of these were designed by Oscar Wenderoth, Treasury Department (supervising architect after Taylor) which show further design refinements with stronger influence of the Spanish Revival style than this building with its Roman details.
The building contains one of the most advanced hot water heating systems in California of its time, and was one of the earliest buildings in the state to use mission tile on a hip roof. 2. Condition of fabric: excellent. B. Description of Exterior: 1. Over-all dimensions: The rectangular building is 82' (seven-bay front) x Across the front of the two story building is a portico measuring 51' x The granite steps across the portico extend out another 8*. SANTA ROSA POST OFFICE HABS No. CA-2051 (Page 5) 2. Foundations: Poured concrete footing with 24" thick brick walls damp-proofed below grade. 3- Wall construction, finish, color: The exterior walls are 18" thick solid-mortared brick construction with every fifth course a header course. Door and window headers are precast reinforced concrete.
The water table (from grade to floor line, approximately is Indiana Buff Bedford Limestone installed in coursed ashlar (total wall thickness The stone is anchored to the brick with a metal U strap in the top of the stone at each side of the vertical joints. Granite is used at the rear steps to the basement. The exterior surfaces are plaster with a heavy texture. The stippling is cement wash heavily applied and then raised apparently by a float tool. The string courses, moldings, and frieze decorations are done, in most cases by heavier sections of plaster which contain pea gravel. The stucco is painted. There was some local concern expressed regarding the stuccoing of the brick.
Experience had been that the stucco peeled off leaving the building in a delapidated appearance (letter from McKinlay to Taylor, February 26, The materials used in construction were listed in correspondence dated December 16, from the Hoyt Brothers to Taylor: Portland cement of the Golden Gate Brand, Pacific Portland Cement Company; the non-staining cement was LaFarge Extra White from France, distributed by Waterhouse & Price Company, San Francisco; Russian River type of sand; crushed rock from the basalt quarries in Sonoma County (the same material used as cobblestone for streets in Sonoma County and San Francisco) was used as aggregate; Indiana Bedford Limestone and Granite; the brick was from Central Brick Company distributed by Western Building Material Company, San Francisco.
Core samples were taken from the brick walls to test their strengths. The compression was pounds per square inch; the shearing stress was 164 pounds per square inch. 4. Structural system, framing: Exterior walls, basement walls and intermediate first floor walls supporting the mezzanine walls are brick. Floors, ceilings, roof, and partitions are wooden frame with four major trusses supporting the roof framing. Floor and roof sheathing is 1" x 6" laid diagonally on floors and straight on the roof. Structural steel is used to support the wooden floor framing above the basement. SANTA ROSA POST OFFICE HABS No. CA-2051 (Page 6) 5. Portico: The 51' x 13* portico across the facade has segmentally arched openings which rest on four Indiana Bedford Limestone columns.
The column shaft is smooth, sits on a base and is topped with a Composite style cap. The columns shafts have the appropriate entasis. The pilasters on each side of the portico also have (square design) a Composite cap. The steps leading up to the portico are of granite and the floor is concrete topped with terrazzo. On each side of the steps are limestone cheek blocks with elaborate cast iron lighting fixtures. Within the portico is a pendant type cast iron fixture. These fixtures were designed to operate on both gas and electricity. The gas piping to these lights still exist. The portico has a simple cornice with brackets at the eaves. 6. Openings: a. Doorways and doors: There are double doors with transoms at either end of the portico. They are of wood and glass.
The doors lead into a main public # lobby where the counters were located. b. Windows: All windows are double hung with removeable stops and chain operated sash weights. Glazing is plate. They were all designed to operate with a pole. The number of lights in top and bottom sash varies from two over two, to twelve over twelve and twenty over twenty at the lobby windows. The windows are inset into two story recessed panels, with the first story windows having keystones. 7. Roof: a. Shape, covering: The roof on the portico is sloped from the main building at the rate of the main roof is hipped with a slope of and The roofing material is a Spanish design clay tile with interlocking feature. The tile was pressed and fired by Ludowici Roofing Tile Company.
The same company continues to manufacture the tile. The original tile was installed using wire ties nailed to the wood decking and the tile (having a rear lug) was laid on 1" x 2" wooden stripping laid horizontally. The tile lug lapped the wooden strip to hold it in place. The tile edges interlocked to provide a water tight surface. tmm SANTA ROSA POST OFFICE HABS No. CA-2051 (Page 7) b. Cornice, eaves: The roof eaves are elaborately detailed with exposed rafters (6" x 10" with decorative end) and paired wooden brackets supporting an exterior beam. C. Description of Interior: 1. Floor plans: a. Basement: There is a full basement with storage, heating equipment, and coal storage areas. Even though the coal chute and storage space was provided, coal was never used. b.
Main floor: The center portion of the building contained the work room and the public lobby. On the left side was the post master's office (with access to secret viewing corridors above the work areas) and the assistant postmaster. The right side had the safe, along with the money order and registered mail counters. From the public lobby (left side) was the # main stair up to the Internal Revenue offices. c. Mezzanine levels: On the left side there are two offices, a toilet, and safe which were used by the deputy collector, Internal Revenue Service. On the right side there is a store room, swing room (lounge), and main toilet rooms with showers which were used by the employees. This area was accessible by a stair from the work room and could be viewed from the secret viewing corridor. d.
Attic: This was accessible from the secret viewing corridors; it provided access to the roof in order to service the flag pole on the ridge. e. Secret viewing corridors: A series of concealed corridors with one way viewing louvers and a series of vertical shafts with ladders provided the postmaster with the ability to go from his office to the basement and attic, seeing all parts of the operation without anyone being able to see him. 2. Stairways: The main stair is an open-well boxed stringer with a u-shaped plan (two intermediate landings). The newel post, railing and turned baluster members are of stained and varnished oak. The bottom treads are curved in a bullnose fashion. This well was enclosed in when a third office space was added to the west mezzanine.
SANTA ROSA POST OFFICE HABS No. CA-2051 (Page 8) 3. Flooring: All the floors are exposed white maple wood except in the public lobby, stair, and toilet rooms which are terrazzo with marble dividers and borders. Wooden baseboards are used with wooden floors and marble baseboards with terrazzo floors. 4. Wall and ceiling finish: Plaster over wooden lath with wooden wainscoting is in the work areas and swing room. Marble wainscoting is installed in the toilet and shower room areas. The main lobby area is done in ornamented plaster friezes, pilasters, and ceiling molds. The pilasters are capped with a Composite style plaster cap (similar to the stone caps on the exterior). The frieze details include egg and dart details, dentils, and acorn units at the pilaster.
Metal lath is used at the ornament portion of the ceiling to wall transition. The wooden lath on the ceilings are installed on strippings (the wooden lath ceiling runs parallel with framing). 5. Doorways and doors: The door casings are molded oak and terminate at the base with a plinth. The doors are # thick stile and rail doors in three designs: raised panels, five high of oak; a glazed panel above with two raised panels below (glazing varies from clear to obscure) of oak; and a small lower panel and large upper panel with diagonal boards (in basement areas). The obscure glazing is of shingle chip glass and patterned glass (bubble type design). 6. Decorative features, trim: All trim, wood work, counters and doors are of quarter sawn white oak which has been stained and varnished. 7.
Hardware: All hardware is plain in a bronze finish. The door locks are mortise type with plain escutcheon plates and oval knobs. 8. Mechanical equipment: a. Heating: The original heating system has been modified and supplemented. The original system was an automatic oil burning plant which operated a hot water heating apparatus. It was one of the first systems of its type in California. This system was made public in the San Francisco Bay Area at the Exposition in San Francisco. The post office SANTA ROSA POST OFFICE HABS No. CA-2051 (Page 9) building system featured an automatic shut off of the fuel system to prevent gas explosions; and a domestic hot water system which provided instant hot water at the lavatories and showers. The system was later converted to natural gas. b.
Lighting: The original lighting fixtures have been removed. There appears to be some evidence that there were gas operated fixtures (probably because electricity was not dependable). It was reported that there were four distinct electrical installations: main lighting with feeder from the street; main power with feeder from the street; vault protection; and a telephone system within the building. All of the electrical work was done in metal conduit. D. Site: The original site including landscaping and a hitching rail for the horses, has been totally altered; now it is concrete paving.
On February 16, Roberts wrote Taylor to note that the "blocks forming the concrete driveway have been troweled forming smooth borders around each joint about 2" wide, the remaining surfaces have been 'drawn' slightly with a wooden trowel to form foothold for horses." Prepared by Dan Peterson, AIA Fourth Street Santa Rosa, California November PART III. PROJECT INFORMATION These records were undertaken by the Santa Rosa Housing and Redevelopment Agency in compliance with Executive Order and a Memorandum of Agreement with the Advisory Council on Historic Preservation as a mitigative effort in the construction of a downtown shopping mall in Santa Rosa, California. John A. Burns AIA was the project consultant.
The architectural and historical written data was prepared by Dan Peterson, AIA Architect, preservation consultant to the Santa Rosa Housing and Redevelopment Agency in November The material was edited in May by Mary Beth Betts in the HABS office. Photocopies of the original drawings, from the collection of Dan Peterson, are included in the photo-data set. Photographs were taken by Don Meacham, in November