This document was prepared as part of the Yosemite National Park Roads and Bridges Recording Project, conducted in summer by the Historic American Engineering Record. Richard H. Quin, Historian BRIDALVEIL FALL BRIDGE NO. 1 HAER No. CA-91 (page 2) II.
This is one in a series of reports prepared for the Yosemite National Park Roads and Bridges Recording Project. HAER No. CA-117, YOSEMITE NATIONAL PARK ROADS AND BRIDGES, contains an overview history of the park roads. History of Bridalveil Fall Bridge No. 1 A small carriage road or path evidently crossed Bridalveil Creek near the base of Bridalveil Fall as early as as it appears on a topographic map prepared that year by Capt. George M. Wheeler of the U.S. Army Corps of Engineers. It was not featured on a map prepared by Wheeler in and may not yet have been constructed. However, Wheeler's earlier map is not as detailed as the sheet, and may have omitted such a small track.
It does not appear on a number of later maps, such as a the topographic map prepared by the Edinburgh Geological Survey in or the map which appeared in the frontispiece of James M. Hutchings' Yo Semite and the Big Trees, published in It can barely be discerned in a map of the Yosemite National Park prepared by Lt. N. F.
McClure of the 1st Cavalry in From its appearance on the map, it can be surmised that the road or trail did exist by this time, probably to provide access to a vista of Bridalveil Fall, always one of the most popular attractions in the Yosemite Valley.1 The road was apparently never the main road on the south side of the Yosemite Valley, as a larger and more direct route was established a little further north when the Washburn-controlled Wawona Road was constructed in The routes of the two roads are shown on the Wheeler map. The south side road connected Pohono and El Capitan bridges, and was apparently a part of the main circuit road of the Valley established by the Board of Commissioners.
The Washburns requested that the Board of Commissioners build a bridge or bridges over Bridalveil Creek on the new road in The old road at the base of Bridalveil Fall remained in use as a scenic diversion. Bridalveil Fall Bridge No. 1 is one of three small bridges constructed on the carriage road at the base of Bridalveil Fall under contract by Oscar Parlier of Tulare, California at a cost of The Government hauled the materials from El Portal at a cost of and also built the stone spandrel walls and roadway.3 The three stone-faced concrete arch bridges are among the last structures built during the administration of Yosemite National Park by the U.S. Cavalry They were the first concrete bridges to have been constructed in the park.
Built to handle carriage traffic, the bridges now carry a foot trail over three small divisions of Bridalveil Creek at the base of Bridalveil Fall (or Pohono, meaning "Puffing Wind"). Another smaller rivulet from the braided stream passes through a culvert between the east and central bridges. BRIDALVEIL FALL BRIDGE NO. 1 HAER No. CA-91 (page 3) The bridges share more similarities than differences. Except for the larger central bridge, which features two spans, each is of basically identical construction. Each is a simple concrete bridge with exposed barrel vault, filled with earth and faced with native granite.
The granite is set in mortar with rough smear joints- Larger stones are used near the tops of the abutments and on the 2' wet masonry construction guard walls running along the sides of the bridges. These guard walls terminate in stone end posts or pylons with half round posts. Each of the spans is 20' wide, and the three bridges are each about 18' feet wide. The two end bridges are 20' long, and the central bridge is twice the length. Wing walls of dry masonry construction with cement caps extend along the approaches to all three bridges. The bridges are in generally good condition, although some of the pavement has washed out on and around the bridges. Since the bridges only carry a foot path, this has presented no severe problem.
The three bridges were the smallest structures documented in the HAER recording project. Bridalveil Fall Bridge No. 1 is a single-span structure, 20' long by 18' wide. Like the other bridges, it has 2' high stone guard walls along the sides, ending in stone pylons with half-round tops; however, the southwest pylon has toppled and is lying on the riverbank below. The bridge is the westernmost of the three structures. BRIDALVEIL FALL BRIDGE NO. 1 HAER No. CA-91 {page 4) III. ENDNOTES 1. Copies of all of the historic maps mentioned may be found in the Yosemite Research Library, and are reproduced in Vol. I of Linda Wedel Greene, Yosemite, The Park and Its Resources: A History of the Discovery, Management, and Physical Development of Yosemite National Park, California. 3 vols.
(Denver, CO: National Park Service, . 2. "Yosemite Valley Interesting Proceedings of the Commission," Mariposa Gazette, 18 June 2. 3. Park Engineer's Report, 15 October in Report of the Acting Superintendent of the Yosemite National Park to the Secretary of the Interior, (Washington: Government Printing Office, 29. Copy in Yosemite Research Library. BRIDALVEIL FALL BRIDGE NO. 1 HAER No. CA-91 (page 5) IV. BIBLIOGRAPHY PRIMARY SOURCES PUBLISHED PUBLIC DOCUMENTS Park Engineer's Report, 15 October in .Report of the Acting Superintendent of the Yosemite National Park to the Secretary of the Interior, (Washington: Government Printing Office,
Wheeler, George M. "Topographical Map of the Yosemite Valley and Vicinity, U.S. Army Corps of Engineers, 10 November SECONDARY SOURCES OTHER DOCUMENTS "Yosemite Valley Interesting Proceedings of the Commission." Mariposa Gazette, 18 June 2.