This recording project is part of the Historic American Engineering Record, a long-range program to document historically significant engineering, industrial, and maritime works in the United States. The HAER program is administered by the National Park Service, U.S. Department of the interior. The Santa Susana Field Laboratory project was cosponsored by Marshall Space Flight Center with guidance and assistance by Ralph Allen, Joseph King, Melvin McKinstry, and Jennifer Groman from NASA Headquarters. The field work and measured and interpretive drawing were prepared under the general direction of Richard O Connor, Chief, Heritage Documentation Programs, National Park Service. The project was managed by Thomas Behrens, HAER Architect and Project Leader.
The measured and interpretive drawings were produced by John Wachtel, Jeremy Mauro, Ryan Pierce, Anne Kidd, Alex Matsov, and Daniel DeSousa. The large- format photographs were taken by Jet Lowe, HAER Photographer. The written historical and descriptive data was produced by Robert Stewart. SANTA SUSANA FIELD LABORATORY, ALFA TEST AREA HAER No. CA-2283 Page 3 Alfa Test Stands The Alfa Test Area Historic District was constructed during it encompassed the first group of operational static test stands for the Air Force Plant (AFP) 57 at Santa Susana. Around the site supported early rocket engine static testing and provided fundamental data for the development of weapons and space vehicle booster systems.
The natural and man-made landscape, as well as the test stands, blockhouse, and ancillary buildings and structures, were constructed by the Los Angeles architectural-engineering firm of Daniel, Mann, Johnson & Mendenhall, with consultant Walter Riedel, a German engineer and rocket engine expert who had worked with Dr. Wernher von Braun s team in Nazi Germany and had been assigned by to NAA in Los Angeles under Project Paperclip. Riedel s influence is apparent as the Alfa site is representative of a static rocket engine test site of the late and early It echoes site planning and design principles modified from late World War II German installations.
The Alfa test stands were the site of multiple static engine tests run between and These programs included tests for developmental Atlas intercontinental ballistic missile engines, Navaho cruise missile engines, Thor and Jupiter intermediate range ballistic engines, Thor engines for space vehicle boosters, Atlas engines for space vehicle boosters, the uprated Thor, and engines for the Delta space vehicle. The structural and dimensional characteristics of Alfa I and III are essentially similar. Consequently, only Alfa I is described in detail. 1 Designed in the Alfa I Test Stand has overall dimensions of approximately 40' in length, 40' in width, and 90' in height. The entire test stand is built of structural steel and supported by concrete pile foundations at the four corners.
Alfa I is generally comprised of two distinct portions: the below-grade flame deflector and the above-grade work decks. The flame deflector has overall dimensions of approximately 16' in width, 13' in depth, and 19' in height and has a separate foundation of steel trusses. The deflector is comprised of an outer and inner steel-plate shell. These shells created a cavity that is connected to pipes that allow water to flow through 1 A detailed description of the Alfa stands and ancillary buildings is included in Archaeological Consultants, Inc., and Weitze Research, Historic Resources Survey and Assessment of the NASA facility at Santa Susana Field Laboratory (Sarasota, Florida and Stockton, California: NASA, SANTA SUSANA FIELD LABORATORY, ALFA TEST AREA HAER No. CA-2283 Page 4 this void.
The inner steel-plate shell had perforations to allow water to exit the cavity and flow over its surface during hot-fire tests, which prevented the steel from melting from the heat of the rocket engine. The deflector directs the water towards the south, where a 75'-long gunite channel further directs the run-off to a collecting pond dug within the terrain. This 4'-deep channel is 18' in width at the deflector, and narrows to a width of 10' where it meets the terrain. Behind the flame deflector, to the north, is a concrete retaining wall. A series of platform decks that constitute the test stand portion begins at ground level. The first deck, known as the dance floor, measures about 40' by and has a 28' square opening in the center, directly over the flame deflector.
This area is fitted with sliding metal-grate panels that can be placed over the opening while the engine is being prepared for testing. Six-feet-wide stationary platforms wrap around the perimeter. The next platform, known as the engine deck , sits approximately 8' above grade, and measures 28' by with a 14' by 14' opening in the center. Like the lower platform, sliding panels fit over the opening for the engine preparation operations, and stationary panels are located around the perimeter. As the name suggests, this level is where the engine is placed for testing procedures. The Second Deck sits at above grade, and measures 33' in length and 30' in width. It has a 14' by 14' opening to allow for the connection pipes from the fuel tanks to the engine.
This level also contains the various indicators, pneumatic panels, and valves that verify the stand is properly functioning. Access stairs for these three levels are the east side of the stand. The fourth platform, commonly referred to as the Fuel Vessel Service Deck, sits roughly 31' above grade, and measures approximately 25' by In the center of this deck sits a vertical fuel tank. The tank is supported by a light steel truss system that wraps around its circumference. There are two additional service platforms supported by the truss. One, the LOX Vessel Service Deck sits 44' above grade and measures roughly 20' by with an opening for the tank. The second platform, called the LOX Vessel Upper Service Deck, measures about by and sits 64' above grade.
In the center of this deck sits the top dome of the LOX tank. These three decks are accessed by caged ladders on the east side. All six platform levels have guard rails around their perimeters. In the early a 5-ton crane was added to the north side of the test stand for engine positioning. Minor additions to Alfa I were completed in for extended SANTA SUSANA FIELD LABORATORY, ALFA TEST AREA HAER No. CA-2283 Page 5 duration testing. The first of these was the relocated vernier engine test stand from the Bravo area.2 It measures approximately 5' by 5', and extends from the west side of the First Deck at the south end. A metal platform provides access from the pavement to the stand.
A 9' extension was also built on the west side of the engine deck and was given a canopy that sits just below the level of the Second Deck. A set of metal steps provides access to this extension. Supported by the was a new 5' by 5' flange service deck. Finally, a fuel tank was added to the Second Deck. To the northeast of the stand is the gauge panel and to the east is the Electrical Control Shack. Alfa I has undergone minor alterations over its lifetime to adapt to reflect new technologies and the requirements for testing different engines. Also designed in the Alfa III Test Stand is structurally similar to Alfa I.
After a period of deactivation during static firings of Atlas booster engines on Alfa I and Thor main block engines continued on Alfa test stands.3 NASA s Glenn-Lewis Research Center in Ohio used the Alfa Site for its LOX testing program in and tests of Lunar Module Rocket Engine assemblies as of mid-1967. The Atlas Missile: The first intercontinental (ICBM) developed and deployed by the United States was the Atlas. Atlas was named after the Atlas of Greek mythology. The concept got its start in 2 A vernier thruster is an engine used on a spacecraft for attitude control. It may be a smaller thrust motor than main attitude control motors, or a small control thruster relative to the main propulsion motors, or may be simply a small thruster of the reaction control system.
Vernier thrusters are used for fine adjustments to the attitude or velocity of a spacecraft and when spacecraft control requirements, such as maneuvering during docking with other spacecraft, dictate a wide range of different thrust levels for attitude or velocity control. 3 NASA February History of the Air Force Plant Representative Office, North American Rockwell Corporation, Rocketdyne Division (Canoga Park, 1 July 31 December 33; History of the Air Force Plant Representative Office, North American Rockwell Corporation, Rocketdyne Division (Canoga Park 1 July 31 December 34. SANTA SUSANA FIELD LABORATORY, ALFA TEST AREA HAER No.
CA-2283 Page 6 with the award of an Army Air Forces research contract to Consolidated Vultee Aircraft, later named Convair, for the study of a 1,500-to-5,000-mile range missile that could conceivably carry a nuclear armed warhead. The first three flights were disappointing. However, they did show that thin walled balloon tanks supported by internal pressure and gimbaled rocket engines were effective concepts. Atlas was unusual in its use of balloon fuel tanks for fuel, which were made of very thin stainless steel (with the uncoated steel necessitating the development by Convair of the anti-corrosive spray with minimal or no rigid support structures. Instead, pressure in the tanks provided the structural rigidity required for flight.
An Atlas rocket would collapse under its own weight if not kept pressurized and had to have 5 psi nitrogen in the tank even when not fueled. By the mid-1950s smaller, relatively lightweight, thermonuclear weapons had been developed. The Central Intelligence Agency (CIA) had information indicating that the Soviet ICBM program was becoming a threat, and Atlas became a national crash program. The Convair Division of General Dynamics built Atlas for the U.S Air Force. In October the rocket became operational as an ICBM. It was used as a first stage for satellite launch vehicles for half a century. On December 18, the launch of Atlas 10B sent the missile into orbit around the Earth carrying the SCORE (Signal Communications by Orbiting Relay Equipment) communications payload.
The Atlas SCORE, at pounds kg) was the heaviest man-made object then in orbit. It was the first voice relay satellite, and the first man-made object in space easily visible to the naked eye because of its mirror-polished stainless-steel tank. Atlas was used as a satellite launcher many years. While its military use ended in surplus Atlas ICBMs were used to loft four Project Mercury astronauts into orbit and became the basis for a group of significant space launch vehicles. Mathematician John von Neumann directed a committee whose mission was to estimate the practicality of building an ICBM capable of conveying a thermonuclear weapon. Von Neumann believed that computers could be developed that were compact and powerful enough to guide a missile.
Atlas E, developed in and F, in were the first iterations that did. SANTA SUSANA FIELD LABORATORY, ALFA TEST AREA HAER No. CA-2283 Page 7 An Atlas booster engine had two large thrust chambers. These were fed by a single common set of turbopumps. The Atlas sustainer engine had a single large thrust chamber and two small vernier engines served by a common set of turbopumps. The verniers provided roll control and final velocity trim. With all five thrust chambers firing, could be developed in Atlas D. The Atlas A-D required radio guidance: the missile transmitted information from its inertial system to a ground station by radio and received course correction information in return.
Atlas models E and F, introduced in had two separate booster engines, each with a single large thrust chamber and independent sets of turbopumps. The E and F variants could develop lb. of thrust. They also had fully self-contained identical inertial navigation systems. The Mariner space probes used to explore Mercury, Venus, and Mars from to used Atlas as the expendable launch system with both the Agena and Centaur upper stages. Atlas powered the Mercury-Atlas missions, sending Lt. Col. John H. Glenn Jr. as the first American to orbit the Earth in The ten Gemini launches of were also powered by Agena-Atlas Target Vehicles used during the Gemini program. SANTA SUSANA FIELD LABORATORY, ALFA TEST AREA HAER No. CA-2283 Page 8 Figure 1: Layout of Alfa Site and Test Stands