Georgia DOT Bridge No. 201-00091-01541N, Spanning Big Drain Creek at State Route 91, Colquitt

Source document Quoted word for word from HAER GA,101-COLQ.V,1-. Not written, edited or summarised by this site.

Spanning Big Drain Creek on State Route 91, east of Colquitt, Miller County, Georgia UTM: Northing-3451460 Easting-721470 Quad: Colquitt, Georgia Date of Construction: Engineer/Builder: Designer - Georgia Highway Department Engineer - C. N. Crocker Builder - Georgia Highway Department, Atlanta, GA

Source document Quoted word for word from HAER GA,101-COLQ.V,1-. Not written, edited or summarised by this site.

GDOT Bridge is significant in the areas of transportation and engineering. It is a continuous-stringer type bridge. Continuous steel stringers are commonly found in Georgia. It is one of approximately 560 bridges of this type found throughout the state and one of five found in Miller County, built prior to This bridge is also representative of those building during the which utilized treated-timber pilings in the substructure and concrete deck and railing in the superstructure. Report prepared by: Thomas C. Queen Transportation Planner II Office of Environment/Location Georgia Department of Transportation Aviation Circle Atlanta, Georgia Date: September Georgia DOT Bridge HAER No.

GA-78 (Page 2) Georgia DOT Bridge constructed in is located on State Route 91 at Big Drain Creek, east of Colquitt. The bridge, which has a timber substructure, is known as a continuous-stringer type with steel I-beams, it is 80 feet long and 24 feet wide, with approaches having 22 feet of pavement and 5-foot shoulders on 100 feet of right-of-way. Georgia DOT Bridge is one of many of its type built by the State Highway Department during the Prior to a variety of bridge types, styles, and materials were used. Beginning around the State Highway Department began to use a somewhat standardized form for most new bridges which used timber pilings in the substructure.

As stated in the Fourteenth Report of the State Highway Board "on numerous occasions where the bridge site warranted a low cost structure without sacrificing strength or durability, a type of bridge was constructed consisting of treated timber pile substructure with I beam joists and concrete floor slab and rail. This type proved very economical and satisfactory" (p. Less expensive than steel or reinforced concrete, wood substructures enabled the department to satisfy transportation needs throughout the state and resulted in a dramatic increase in bridge construction.

The demands for material and manpower during the Second World War practically stopped the construction of bridges in Georgia from to Only essential projects providing access to war- related industries and roads on the Strategic Highway Network were placed under construction. In the post-war years, timber was no longer used as a bridge-building material by the department. According to the Twenty-Second Report of the State Highway Department "timber of sizes and stress grades required for the construction of timber bridges has all but disappeared from the local market. Delivered price of timber shipped from the Pacific Coast is too high for consideration.

It has, therefore, been necessary for the Division of Bridge and Road Design to develop a design for a low-cost bridge built of available material that will meet the need formerly filled by timber bridges. This design provides a bridge of steel and concrete, stronger and durable than timber bridges and costing but a small traction more" (p. Timber substructures are an identifying characteristic of many of the bridges built in Georgia from to It was also during this time that reinforced concrete balustrades, with horizontal and/or vertical members, emerged as a popular material for bridge railing. Concrete balustrades, with horizontal members resembling a fence rail, such as those found on the subject bridge, were used extensively through the and