The office and firehouse is a contributing structure in the United Engineering Company Shipyard historic district that has been determined eligible for the National Register of Historic Places. The United Engineering Company Shipyard, established in to build and repair ships for the U.S. Navy, is the last surviving of several large World War II shipyards in Alameda. United Engineering built 21 tugboats and repaired hundreds of ships during the war. The facility was one of the largest employers in Alameda and played an important economic and social role in the city. This building played a supporting role in the shipyard and reflects the dangerous working conditions in the provision of a private, on-site firehouse.
Description: The office and firehouse is located just north of the large Inspection and Repair Shops building and south of the bending shops in the Alameda Gateway complex. The office and firehouse is a one-story rectangular-shaped building oriented east-west. It measures approximately 42 feet across the north and south sides and 37 feet across the east and west ends. The structure has a total area of about square feet. Building is rather plain in appearance, but unlike many of the buildings constructed at the yards from to the office and firehouse has some ornamentation. Exposed rafters and brackets under the windows are similar to details on a Craftsman bungalow. Building 21 rests on a foundation of wood posts.
The building is composed of a wood-frame structural system covered with horizontal wood V-groove siding on the exterior. There is a two-part addition across the back of the building that also has a frame structure but is covered with corrugated metal siding and plywood. The roof over the main part of the building is gabled with a low pitch and is covered with asphalt rolled strip roofing. The rear additions have shed roofs covered with corrugated metal. There is a small vent on the main roof. 4 UNITED ENGINEERING COMPANY SHIPYARD, OFFICE AND FIREHOUSE (Building No. Building No. 21) HAER No. CA-295-M (Page 2) Most windows are double-hung with wooden sashes. Several doorways have the original half-glassed wooden doors, but others have been replaced with wood hollow core doors or plywood.
The garage doors on the east side of the building appear to be original. Building 21 has been substantially altered on the interior and as a result has a complicated floor plan. The building is divided into three parts, each accessible only from the exterior. The rear of the building (the two rooms labeled "Storage" on the plan) has doors on the east and west ends. The front of the building is divided into a larger section on the west end and a smaller section on the east end. The larger section has two rooms (labeled "Marine Canvas Shop" on the plan) with two exterior doors on the south side and one on the west end. The smaller section has three rooms (labeled "Office" on the plan), each accessible from a door on the east end of the building.
The walls and ceiling are covered with painted plywood. The floors are covered in linoleum tiles. The building has electricity and a gas furnace. Close to the time of construction, in the building had an "L" shaped plan. Since that time the interior angle has been filled and shed additions added across the back the length of the building. The materials and workmanship of the additions is similar to other buildings constructed in the shipyard in the and and is likely from that period. In the interior, the wall that divided what were the boiler maker's locker room and ship fitter's locker room was mostly removed, and a hallway open to the exterior was added to the east end of the building.
Aside from the alterations to the interior and the additions to the rear the building is intact and appears to be in good condition. Historical Context: The office and firehouse was built in the early during a construction campaign by United Engineering. The company quickly built numerous buildings to accommodate shipbuilding and repair necessitated by U.S. involvement in World War II. Building was genetically called a "portable building" but its purpose was to house firefighting equipment and personnel that served the entire shipyard. Shortly after it was constructed at a cost of in October of plans were drawn for revisions to the building although it is not clear what the changes were. The plans show that the main section of the building was divided into a grid of six rooms.
The largest rooms on the west end were a "boiler maker's locker room" and a "ship fitter's locker." In the middle there was a C UNITED ENGINEERING COMPANY SHIPYARD, OFFICE AND FIREHOUSE (Building No. Building No. 21) HAER No. CA-295-M (Page 3) "work shop" and a "material's checkers." On the east end there was an office for the "fire chief and "O. MacGregor's office." At the east end of the back of the building (the north side) there was a long space used for housing the "fire engine." On the Sanbom Map of this building was labeled no. In the Alameda County Recorder listed this building as no. 43. Sometime during the ownership of Todd Shipyards Corporation, this came to be known as building no.
A fire truck, possibly one formerly stored in the firehouse, is located to the east of the bending shops, north of this building. A sail making business called the "Marine Canvas Shop" currently occupies the building.